Trailer of the netflix movie they're talking about - https://www.youtube.com/watch?v=lM_hkJ0Rl-c
Shadow
joined 1 year ago
MODERATOR OF
If my dog has poop stuck to his butt he comes over and whimpers at me for help. My cat smears it all over my floor.
That's a pretty disturbing story, and I never would have imagined they would not tell a victim. I understand the argument against it, but the risk of long term mental illness / PTSD from it being suppressed just seems way too high.
He was always a scum bag, but 911 made him seem like a golden boy for a little while.
Zigbee and wifi do clash a bit more, but after I set my channels I've never had problems: https://www.metageek.com/training/resources/zigbee-wifi-coexistence/
My zwave has been bulletproof though. I suspect something is wrong with your setup, I assume you've tried things like healing the network?
Is your stick on a USB extension cable or hub extended away from your pc? That can help quite a bit.
I moved trom Saxx to Bn3th because I found they stretched out less over time and thus last longer.
Design wise they're practically identical to Saxx.
It's just you. Have you considered zigbee?
Take the door off. Use a knife to score the existing silicone and then pull the glass out. Use a razor blade and knife to clean up the existing silicone. Clean the surfaces well.
Get silicone bathroom caulk from home depot. Put some in the channel, put the glass back, put more along the seam. Use a wet finger to smooth it out.
Tape it in place while it cures and you're done.
I'm kinda surprised a piece with an attached door is just siliconed in place. Is there no retention screw or anything?
Hl3 confirmed.
No problem, just tab complete your way around the filesystem.
The generic Advil don't have the candy coating.
I've been messing around with circuits my entire life but this design was time sensitive and I've never done my own PCB designs before, so I hired someone to put this together. After getting some test boards, when I plug them in the charger chip gets very hot and smells like burning....
Circuit is just a simple li-ion usb charger and a switch. I've gone through the datasheet for the bq25302 more times than I can count and I'm missing something obvious here. Using it just for delivering power seems to work fine, the problem is only when charging.
I do see R6 + R7 off TS don't have the recommended 10k values, but I don't feel like that would cause what I'm seeing. This is being connected to a 21700 lipo.
Someone mind lending me their eyes please?
bq25302 datasheet - https://www.ti.com/lit/ds/symlink/bq25302.pdf
view more: next ›
Sar?